The project is solved in EPLAN / ELCAD: single-line diagram, power distribution, PLC I/O list, panel layout and BOM are prepared and approved by the client.
The enclosure is prepared to the approved design; mounting plate, busbar system, switchgear and control equipment are installed. Painted RAL 7035 or stainless AISI 304 / 316.
Power and signal wiring with standards-compliant cross-sections and colour codes; every cable and terminal is labelled, door devices (buttons, lamps, HMI) connected.
Connection checks, insulation and function tests before energising; PLC / HMI scenario tests. The factory acceptance test (FAT) is run with the client and reported.
Panels are packed with protective wrapping and delivered to site with as-built documents. Transport is planned to the delivery location.
Energising on site, drive parameterisation, PLC / SCADA integration and site acceptance tests (SAT). Handover with operator training; after-sales support continues.
We will clarify the scope together and get back to you with schedule and quote.
